vypis lspci:
[root@ntBasus 3xtr4ct]# lspci | grep -i bcm
04:03.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
a zde cast vypisu jadra:
bcm43xx driver
ACPI: PCI Interrupt 0000:04:03.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ
10
bcm43xx: Chip ID 0x4318, rev 0x2
bcm43xx: Number of cores: 4
bcm43xx: Core 0: ID 0x800, rev 0xd, vendor 0x4243
bcm43xx: Core 1: ID 0x812, rev 0x9, vendor 0x4243
bcm43xx: Core 2: ID 0x804, rev 0xc, vendor 0x4243
bcm43xx: Core 3: ID 0x80d, rev 0x7, vendor 0x4243
bcm43xx: PHY connected
bcm43xx: Detected PHY: Version: 3, Type 2, Revision 7
bcm43xx: Detected Radio: ID: 8205017f (Manuf: 17f Ver: 2050 Rev: 8)
bcm43xx: Radio turned off
bcm43xx: Radio turned off
r8169 Gigabit Ethernet driver 2.2LK-NAPI loaded
ACPI: PCI Interrupt Link [LNEA] enabled at IRQ 5
PCI: setting IRQ 5 as level-triggered
ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNEA] -> GSI 5 (level, low) -> IRQ
5
PCI: Setting latency timer of device 0000:02:00.0 to 64
eth1: RTL8168b/8111b at 0xffffc2000002a000, 00:18:f3:40:24:87, IRQ 5
hda: ATAPI 24X DVD-ROM DVD-R-RAM CD-R/RW drive, 2048kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.20
input: PC Speaker as /class/input/input4
ieee1394: Initialized config rom entry `ip1394'
sdhci: Secure Digital Host Controller Interface driver, 0.12
sdhci: Copyright(c) Pierre Ossman
sdhci: SDHCI controller found at 0000:04:01.2 [1180:0822] (rev 17)
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 5
ACPI: PCI Interrupt 0000:04:01.2[C] -> Link [LNKD] -> GSI 5 (level, low) -> IRQ
5
sdhci:slot0: Controller reports > 25 MHz base clock, but no high speed support.
mmc0: SDHCI at 0xdf7ff800 irq 5 DMA
shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
ACPI: PCI Interrupt 0000:04:01.1[B] -> Link [LNKC] -> GSI 11 (level, low) -> IRQ
11
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[df7ff000-df7ff7ff] Max
Packet=[2048] IR/IT contexts=[4/4]
i2c_adapter i2c-0: nForce2 SMBus adapter at 0x600
i2c_adapter i2c-1: nForce2 SMBus adapter at 0x700
ACPI: PCI Interrupt Link [LAZA] enabled at IRQ 10
ACPI: PCI Interrupt 0000:00:10.1[B] -> Link [LAZA] -> GSI 10 (level, low) -> IRQ
10
PCI: Setting latency timer of device 0000:00:10.1 to 64
hda_codec: Unknown model for ALC861, trying auto-probe from BIOS...
ieee1394: Host added: ID:BUS[0-00:1023] GUID[00e018000367f691]
floppy0: no floppy controllers found
lp: driver loaded but no devices found
SELinux: initialized (dev ramfs, type ramfs), uses genfs_contexts
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
Mobile IPv6
ACPI: AC Adapter [AC0] (on-line)
Asus Laptop ACPI Extras version 0.30
Error calling BSTS
unsupported model A6M, trying default values
send /proc/acpi/dsdt to the developers
ACPI: Battery Slot [BAT0] (battery present)
input: Power Button (FF) as /class/input/input5
ACPI: Power Button (FF) [PWRF]
input: Sleep Button (CM) as /class/input/input6
ACPI: Sleep Button (CM) [SLPB]
input: Lid Switch as /class/input/input7
ACPI: Lid Switch [LID]
input: Power Button (CM) as /class/input/input8
ACPI: Power Button (CM) [PWRB]
No dock devices found.
ibm_acpi: ec object not found
ACPI: Video Device [VGA] (multi-head: yes rom: no post: no)
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
EXT3 FS on hdc3, internal journal
kjournald starting. Commit interval 5 seconds
EXT3 FS on hdc2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
SELinux: initialized (dev hdc2, type ext3), uses xattr
SELinux: initialized (dev tmpfs, type tmpfs), uses transition SIDs
kjournald starting. Commit interval 5 seconds
EXT3 FS on dm-0, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
SELinux: initialized (dev dm-0, type ext3), uses xattr
SELinux: initialized (dev hdc1, type vfat), uses genfs_contexts
Adding 1048568k swap on /dev/VolGroup00/LogVol00. Priority:-1 extents:1 across:
1048568k
SELinux: initialized (dev binfmt_misc, type binfmt_misc), uses genfs_contexts
ip6_tables: (C) 2000-2006 Netfilter Core Team
ip_tables: (C) 2000-2006 Netfilter Core Team
Netfilter messages via NETLINK v0.30.
nf_conntrack version 0.5.0 (3583 buckets, 28664 max)
SoftMAC: ASSERTION FAILED (0) at: net/ieee80211/softmac/ieee80211softmac_wx.c:30
6:ieee80211softmac_wx_get_rate()
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
SoftMAC: Associate: Scanning for networks first.
SoftMAC: Associate: failed to initiate scan. Is device up?
bcm43xx: PHY connected
bcm43xx: Microcode rev 0x15f, pl 0x75 (2006-06-10 00:12:21)
bcm43xx: Firmware: no support for microcode extracted from version 4.x binary dr
ivers.
bcm43xx: core_up for active 802.11 core failed (-95)
r8169: eth3: link up
r8169: eth3: link up
SELinux: initialized (dev rpc_pipefs, type rpc_pipefs), uses genfs_contexts
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.8
Bluetooth: L2CAP socket layer initialized
audit(1178211896.536:3): avc: denied { net_bind_service } for pid=2101 comm="
sdpd" capability=10 scontext=system_u:system_r:bluetooth_t:s0 tcontext=system_u:
system_r:bluetooth_t:s0 tclass=capability
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
Bluetooth: HIDP (Human Interface Emulation) ver 1.1
SELinux: initialized (dev autofs, type autofs), uses genfs_contexts
SELinux: initialized (dev autofs, type autofs), uses genfs_contexts
eth3: no IPv6 routers present
bcm43xx: Microcode rev 0x15f, pl 0x75 (2006-06-10 00:12:21)
bcm43xx: Firmware: no support for microcode extracted from version 4.x binary dr
ivers.
bcm43xx: core_up for active 802.11 core failed (-95)
Nevíte, jak proč se to nechytá podle zde uvedeného postupu, nebo jak vyřešit to zamrzání?