Fedora7 a fwcutter

Dobry den,

omlouvam ze tu resit opet toto tema, ale naistaloval jsem FEdoru a royjiydim podle navodu: http://drpixel.tuxfamily.org/index.php?2007/07/06/73-carte-wifi-broadcom-et-fedora-7

Mohl bysme me nedko poradit s tou posledni casti. Tady odtud nevim jak dal. Nejsem moc dobry anglicninar, ale asi po me chteji abych zjitstil to id moji karty a to prave vubec netusim jak :frowning:

You must get the PCI ID of your Broadcom Wireless card.

lspci -n | grep 14e4:43 | awk ‘{ print $3}’@@

On my NX6125 computer, this give me : 14e4:4318

echo “14e4 4318” > /sys/bus/pci/drivers/bcm43xx/new_id

(you must replace the : by a space)


In order to use the bcm43xx module by NetworkManager, you need to restart the services

service NetworkManager restart
service NetworkManagerDispatcher restart

Now the wireless connexion works perfectly


Unfortunately you must do the modpobe and the modification of /sys/bus/pci/drivers/bcm43xx/new_id at every boot.
The simplest way even if this is not the best one , is to modify the /etc/rc.local file :

echo ‘modprobe bcm43xx’ >> /etc/rc.local
echo ‘echo “‘14e4 4318’” > /sys/bus/pci/drivers/bcm43xx/new_id’ >> /etc/rc.local

These command will add the following line at the end of the /etc/rc.local file:

modprobe bcm43xx
echo “14e4 4318” > /sys/bus/pci/drivers/bcm43xx/new_id

You’re done. The Wifi now works well at every boot!

A co z toho je ta posledni cast? To je cele jako posledni cast?
Pak chteji abyste provedl prikaz
lspci -n | grep 14e4:43 | awk ‘{ print $3}’@@
jeho vystupem bude cosi jako
pokud jeho vystupem nic takoveho neni, nemate broadcom bc43xx kartu
Nasledni pridejte do /etc/rc.local dva radky (treba pomoci geditu)
modprobe bcm43xx
echo “tady bude vase cislo, kde dvojtecku nahradite mezerou” > /sys/bus/pci/drivers/bcm43xx/new_id

restartujte (pokud byste ony dva prikazi provedl rucne, neni potreba restartovat).